Syntax Errors not attached
I run into this problem when I work from home. At the office my syntax errors are not attached anymore to the ECL IDE window. I have not been able to figure out how to attach it. Anyway, it is on the second monitor at work. When I work from home, I can't see it since I am just working from the laptop screen. It apparently is on the invisible other screen. So in order to see my errors I have to submit the job. Not good. How can I fix this.
Another Note: I just got it attached somehow. I don't know what I did. I moved it over the window and clicked on it.
Another Note: I just got it attached somehow. I don't know what I did. I moved it over the window and clicked on it.
- georgeb2d
- Posts: 93
- Joined: Wed Dec 24, 2014 3:36 pm
georgeb2d,
You can always put the ECL IDE back into its default configuration then move things around again to the way you like them. The Ribbon bar has a View tab and at the right end of that tab are the reset buttons (both default left and default right).
HTH,
Richard
You can always put the ECL IDE back into its default configuration then move things around again to the way you like them. The Ribbon bar has a View tab and at the right end of that tab are the reset buttons (both default left and default right).
HTH,
Richard
- rtaylor
- Community Advisory Board Member
- Posts: 1619
- Joined: Wed Oct 26, 2011 7:40 pm
2 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 1 guest